Scattered light imaging through complex turbid media has significant applications in biomedical and optical research. For the past decade, various approaches have been proposed for rapidly reconstructing full-color, depth-extended images by introducing point spread functions (PSFs). However, because most of these methods consider memory effects (MEs), the PSFs have angular shift invariance over certain ranges of angles. This assumption is valid for only thin turbid media and hinders broader applications of these technologies in thick media. Furthermore, the time-variant characteristics of scattering media determine that the PSF acquisition and image reconstruction times must be less than the speckle decorrelation time, which is usually difficult to achieve. We demonstrate that image reconstruction methods can be applied to time-variant thick turbid media. Using the time-variant characteristics, the PSFs in dynamic turbid media within certain time intervals are recorded, and ergodic scattering regimes are achieved and combined as ensemble point spread functions (ePSFs). The ePSF traverses shift-invariant regions in the turbid media and retrieves objects beyond the ME. Furthermore, our theory and experimental results verify that our approach is applicable to thick turbid media with thickness of 1 cm at visible incident wavelengths.

Stereoscopic microscopy is a promising technology to obtain three-dimensional microscopic images. Such microscopes are based on the parallax effect, and as such require two lenses to focus at two different points. Geometrical constraints, however, restrict their numerical apertures to about 0.2, thus limiting the system’s resolution. Higher numerical apertures (∼0.35) can be achieved with designs using only one bulk lens, but such systems are ∼10 times more costly than the conventional ones. Thus, there is a pressing need for alternative solutions to improve the resolution of stereoscopic systems. Here, we show that high-resolution and low-cost stereoscopic systems can be obtained using birefringent single-layer metalenses. We design and fabricate a birefringent metalens operating at 532 nm with a numerical aperture as high as 0.4. The metalens is then used to demonstrate high-resolution stereoscopic imaging of biological samples. The microscopic images are further displayed and perceived vividly in an autostereoscopic display. Our demonstration paves the way to a new strategy to achieve high-resolution and low-cost stereoscopic microscopes.

A constant elastic alloy is a widely used material with a high elastic modulus and an excellent wave velocity consistency. Different morphologies on the constant elastic alloy surface are observed through femtosecond laser irradiation. When the laser average fluence is set to 0.58 J/cm2 and 200 laser pulses, with the increasing depth of distilled water, the period of the laser-induced periodic surface structures (LIPSS) becomes shorter accordingly. The higher the ethanol concentration is, the more spot-shaped structures will be formed among the surface structures when the depth of the coverage of ethanol is 2 mm. The period of the LIPSS reaches its maximum when the concentration of ethanol is 80%.

A fused silica glass micro-channel can be formed by chemical etching after femtosecond laser irradiation, and the successful etching probability is only 48%. In order to improve the micro-channel fabrication success probability, the method of processing a high-temperature lattice by a femtosecond laser pulse train is provided. With the same pulse energy and scanning speed, the success probability can be increased to 98% by optimizing pulse delay. The enhancement is mainly caused by the nanostructure, which changes from a periodic slabs structure to some intensive and loose pore structures. In this Letter, the optimum pulse energy distribution ratio to the etching is also investigated.